Cabling
Verify that the cabling type is correct. Make sure all cable connectors are securely
seated in the required ports. Use only standard Unshielded Twisted-Pair (UTP),
Category 3, 4, 5, or 5e cables. Use only Category 5 or 5e when connecting with Fast
Ethernet. Make certain the maximum distance between the Switch and what it’s
connected to is 100 meters or less.
NOTE:
Do not plug a standard telephone cord into an RJ-45 port. This may damage
the switch
Hereby ASSMANN Electronic GmbH, declares that this device is in compliance with the
requirements of Directive 2014/30/EU (EMC), Directive 2014/35/EU (LVD) and the Directive
2011/65/EU for RoHS compliance. The complete declaration of conformity can be requested
by post under the below mentioned manufacturer address.
Note:
If wrongly installed or improperly used in the living area, the device can cause interference in
radios and other electronic devices. Appropriate use is when the device, as far as feasible, is
operated with shielded connection cables (with network products in addition to category 5
shielded cables and higher). The device has been tested and falls within the limits of class A
computing equipment according to the requirements of EN 55032.
Warning:
This device conforms with test category A - it can cause radio interference in the living area; in
this case the operator may demand that appropriate measures are implemented and arise for
this reason. Declaration of conformity: The device fulfills the EMV requirements according to
EN 55032 for ITE and EN 55024 class A. In this way, the fundamental protection requirements
of the EMV-2014/30/EU guideline are fulfilled.
www.assmann.com
Assmann Electronic GmbH
Auf dem Schüffel 3
58513 Lüdenscheid
Germany
