Digitus Biometrics dbServerRackV2 Zero-U, Руководство пользователя и инструкция по установке

Страница: 5 / 24

Model: db ServerRack V2 Zero-U Digitus Biometrics, Inc. 2011
Page 5 of 24
Mounting the Door Interface Box
•
If you are installing the db ServerRack Access Control unit to a cabinet that already has a lock installed, remove the
existing lock at this time.
•
The "Door Interface Box" provides an interface between the Control Unit and the fingerprint scanner. It also provides
all power and signal connections to the electric lock.
•
Install the Door Interface Box as show in Figures 4 thru 9.
Mounting the Door Interface Box - Step 1
•
Before removing the double-sided high bond tape from the Door Interface Box, find a suitable location on the inside
of the cabinet door to mount Interface Box.
•
Ensure that the selected location will not affect the cabinet door from closing correctly.
•
Note that for glass paneled cabinet doors with very narrow frames, the only suitable location may be on the glass.
IMPORTANT:
•
Ensure that the Interface Box is located close enough to the lock opening in the door, so that the finger-
sensor on the ribbon cable can go through the door and connect into the lock, see Figure 6.
•
Once you have found a suitable location where you intend to mount the Door Interface Box, ensure that the door
surface is clean and free from any debris. (Using neat alcohol to clean the surface is highly recommended. Allow
drying time before proceeding.)
•
Remove the protective cover from the double-sided high bond tape located along the edge of the Door Interface
Box.
Figure 4