SETTING BASIC DATA
11
100 SPEED SIGNAL COUNT
This is a side function to get information about distance traveled in 100 speed
signals.
Pull/tow seeding machine on field until 100 speed signals are counted, then
measure distance traveled between 0. and 100. signals with a measure tape
on the ground. Enter distance value in the monitor in centimeters.
Speed sensor is an inductive sensor which detects bolt heads of a driven wheel.
In case of individual installation the number of signalling bolt heads must be
enough to provide at least one signal at
every 30-60 cms distance traveled and
it may not exceed 100 cms.
Readiness for operation
is indicated by a flashing
SPEED SENSOR LED
on
the monitor. Accurate measurement can be reached if
speed sensor exactly
aligns bolt head
when starting calibration. Besides signal counter on screen
watch this red LED
as well, which shows you how sharply the sensor aligns
the bolt head, both at start and end points.
SETTING OF DISTANCE TRAVELED IN 100 SPEED SENSOR
SIGNAL
The distance traveled can be determined either:
•
by MEASUREMENT: with a measure tape ( it is always more
accurate method since average slip is also included)
•
by CALCULATION:
×
wheel perimeter (cm)
ENTRY OF WORKING WIDTH
Seeding machine working width is adjustable between 0.75-30 meters
Working width can be calculated: row number multiplied by row spacing.
100 sign: 000
Dist: 58.4 m
One touch: spin up
Pushed continuously: spin up in quick time
W.width: 04.5 m
One touch: spin up
Pushed continuously: spin up in quick time
100
number of bolt
heads
