Digitrax Zephyr xtra, Руководство пользователя

Страница: 42 / 66

3. Once the speed step setting you want to use is in the display, press the
exit
key to complete the speed step setting change and return to regular operat-
ing mode. Once this change is made, the DCS51 command station will send
DCC commands to the edited decoder in the speed step setting you entered.
24.0 SWITCH Mode
Switch Mode is used for sending commands to accessory decoders and for
changing Option Switches (OpSw) in your DCS51. The most common use of
switch mode is for operating turnouts. The DCS51 remembers the current
switch setting of switch numbers 1 to 512 during the session. For convenience
it will allow switch numbers from 513 to 999 to also be selected and controlled
on the layout. Switch commands may also be used for controlling Digitrax
compatible signal units.
To change the position of a turnout:
This section assumes that you have already installed and programmed turnouts
and turnout decoders on your layout.
1. Press the
SWitCh
Key.
2. The last switch address selected by your throttle is displayed followed by a
or a . The SWITCH Indicator Dot is lit to remind you that you are
in Switch Mode.
Digitrax uses the following convention for position information
for turnouts:
indicates that the switch is “thrown”
(for a turnout this means that the diverging route is set)
indicates that the switch is “closed”
(for a turnout this means that the mainline route is set)
©2012 Digitrax, Inc. www.digitrax.com 41