11.
Mode/(Hold)Program
- This button is used to put the XP-300 in and out of User mode. The beauty of
the User mode is, that the XP-300 will give you the opportunity to store up to 6 of your favorite factory
programs in the same area. This will save you the toe-tap dancing ritual of accessing programs.
To store a Factory program to a User program location
, the procedure is as follows:
First, select the Program to be stored. Press and hold the
<MODE/(Hold)PROGRAM>
button. The
display will flash:
U1
.
From here, use the
<UP/(Hold)DOWN>
footswitch to select which user
location. Now just press the
<MODE/(Hold)PROGRAM>
button to save. The display will read:
SA
to confirm, then return to Program mode.
To Reset the XP300 and Calibrate the Expression Pedal,
the procedure is as follows:
Press and hold the
<BYPASS/(Hold)TUNER>
foot switch while applying power to the XP-300
until the display will read:
rs
. Release the foot switch and wait for the display to read:
CA
and
Pd
. When the display reads:
Pb
, rock the pedal back and press a foot switch. This display
will then read:
PF
. Rock the pedal forward and press a foot switch. The expression pedal is
now calibrated. If the pedal did not calibrate properly the display will read:
Er
in which case
you need to repeat this procedure again.
12.
AC Line Input
- Connect the power adpater here. Use only the enclosed PS 750 power supply.
Tuner Mode
To access the Tuner mode, press and hold the
<BYPASS/(Hold)TUNER>
footswitch until:
tu
appears in the
display.
T
he currently played note is displayed in the left character of the status display window, while the
intonation is displayed in the RIGHT character of the window.
When the input note is in tune, the display will read:
When the note is flat, the intonation character will rotate counter clockwise as shown:
When the note is sharp, the intonation character will rotate clockwise as shown:
The faster the character spins (either clockwise or counter clockwise), the more out of tune the note is.
Bypass Mode
To place the XP-300 in bypass mode, press the
<BYPASS/(Hold)TUNER>
footswitch once.
When the XP is in Bypass mode, the Expression pedal is inactive, but programs can still be selected using
the
<UP/(Hold)DOWN>
footswitch while the unit is in bypass. The new program is loaded once Bypass
mode is exited. When the XP is in bypass mode, the display will read:
