Applying Power
There are two options for powering the RP100 Artist: battery power and AC power. Before
applying power to anything, set your amp(s) to a clean tone and set the tone controls to a flat
EQ response (on most amps, this would be 0 or 5 on the tone controls).Then follow the steps
listed below.
Battery Power
The RP100 Artist can be run for about 8 hours on 6 AA batteries.The battery compartment is
located on the bottom of the RP100 Artist.The following diagram shows the correct polarity for
battery installation.
Connecting your instrument to the
Input
of the RP100 Artist will engage the battery power and
disconnecting your instrument from the
Input
of the RP100 Artist will disengage the battery
power. Once the connections have been made, and the RP100 Artist is powered (indicated by
numbers appearing in the Display), turn the RP100 Artist’s
Master Level
(far right knob) all the
way down.Turn your amplifier(s) power switch to the on position and adjust the volume(s) to a
normal playing level. Gradually increase the RP100 Artist
Master Level
to achieve the desired
volume.
To prolong the battery life, disconnect your instrument from the RP100 Artist’s
Input when not in use
.
8
Содержание RP100A
Страница 1: ...User s Guide...
Страница 7: ...A Guided Tour of the RP100 Artist The Front Panel 2...
Страница 36: ......
