DigitaLinx DL-HDM44-FS, Инструкция по установке и эксплуатации

Страница: 9 / 28

DL-HDM44-FS Installation Guide
9
Connect Sources
Connect Displays
Connect the source devices to HDMI inputs using HDMI cables that are less than or equal to 5 meters in length
for 4k30 signals. For source devices that are further away, it is highly recommended to install a Digitalinx
DL-HD70 or DL-HDE100.
Connect the display devices to HDMI outputs using HDMI cables that are less than or equal to 5 meters in
length for 4k30 signals.. For display devices that are further away, it is highly recommended to install a Digitalinx
DL-HD70 or DL-HDE100.
Connect External IR Control
If IR extension is required, connect the TRS 3.5 mm plug IR RX to the matrix IR EXT port, ensuring the IR receiver
eye is placed in clear view of the handset used to control.
Insert the matrix power supply included and switch on power located on the front panel. Check that the front
panel LED screen is on to indicate the matrix is ready for use.
Applying Power
Switching Capabilities
Switch between sources and displays using the matrix front panel buttons, IR remote control, serial RS232,
or LAN. To set a route using the front panel of the DL-HDM44-FS, press the desired Input button (Source) and
desired Output button (Display), then press Take.