Instructions
1. Verify all components included with the extender set are present before
installation.
2. If the DL-DA12S is to be mounted under furniture or vertically, attach the
included mounting brackets to the device and secure it to the surface with
appropriate mounting hardware.
3. If the DL-DA12S is to be resting on a finished surface, attach the included
rubber feet to the bottom of the device to prevent any damage to the surface.
4. Connect the source device to the HDMI input using an HDMI cable that is
less than or equal to 5 meters in length. If the source device that is further away,
it is highly recommended to install a Digitalinx DL-HD70 or DL-HDE100 or active
HDMI cable solution.
5. Connect the display devices to HDMI outputs using HDMI cables that are less
than or equal to 5 meters in length. For display devices that are further away, it
is highly recommended to install a Digitalinx DL-HD70 or DL-HDE100 or active
HDMI cable solution.
6. Plug the power supply into the power input port on the rear of the distribution
amplifier.
7. The input LED will light when a source is detected on the input. The output
LEDs will light when a display is detected to the corresponding output.
Troubleshooting Tips:
Abnormal color or no video
•
Verify cables are securely connected to source, displays, and DL-DA12S.
•
Verify the display(s) can accept the provided video resolution and color space.
Output LED is off when active display is connected
•
Verify active display is HDCP compliant.
•
Verify proper input is selected on active display.
•
Disable HDCP encrypted source content, then power cycle DL-DA12S
Input LED is flashing
•
Input video stream is not passing HDCP encrypted content
•
Input video stream was not passing HDCP encrypted content when DL-DA12S
was powered on.
