The Digitalinx DL-DA12S is a one input to two output HDMI distribution
amplifier (DA). The DL-DA12S supports 3D and 4K video resolutions as
well as multichannel audio formats.
The EDID setting for the DL-DA12S is defined by the first detected
display. The DL-DA12S features diagnostic LEDs on the front of the
product indicating the state of the connections into and out of the
unit.
Diagnostic LEDs:
The DL-DA12S provides four LEDs to indicate the current operating status and to
assist troubleshooting an installation.
Power:
Solid, the DL-DA12S is receiving power from the power supply.
Input:
Flashes once per second, the input signal is not encrypted. Solid, the input
signal is encrypted. Not lit, no input signal is detected.
Out 1, Out 2:
Solid, video is passed to an active display.
EDID Management:
The EDID setting for the DL-DA12S is defined by the first detected display.
For example, the display on Out 1 supports 4K video. When the source plays 4K
content, it will pass to all displays. If a display does not support the video content,
there will be no video output on the display.
Important notice:
•
Do not attempt to disassemble or alter the extender housing. There are no user-
serviceable parts inside the unit. Doing so will void your warranty.
•
To minimize the possibility of equipment damage from electrostatic discharge (ESD), all
source and destination equipment must be powered off during installation.
•
Do not connect the extender to a telecommunication outlet wired to unrelated
equipment. Doing so may damage the unit or any connected equipment. Ensure all connected
twisted pair cabling is straight-through (point-to-point).
•
Allow proper ventilation to reduce the risk of thermal failure.
Firmware Port:
A separate document will provide usage instructions once a new firmware update is
available.
