DIGITAL YACHT
WL400 Quick Start Guide
Windows will now search the USB Memory stick for the correct drivers and install them. While it is searching and
installing, you will see the window shown in Figure 11. When it has completed and the drivers are successfully installed,
you will be shown the window in Figure 12.
You can now close this window and the Device Manager window and you are ready to use the WL400 to find and connect
to a wireless hotspot. Proceed to the “Operating WL400 on Windows Vista and Windows 7” section.
Installation for Windows XP
The easiest method of installing the drivers on a
Windows XP computer is to run the Setup.Exe file that is
on the USB Memory Stick. This installs both the drivers
and the Realtek Utility that can be used in place of the
normal Windows Wireless Zero Configuration program
that came with Windows XP. The same Setup.Exe
program can be used for installing the WL400 on
Windows Vista or Windows 7 PCs but we would always
recommend following the On-Line or Off-Line procedures
detailed in the previous sections.
Navigate to the Setup.Exe file on the USB Memory Stick,
by clicking the Start button and then clicking on “My
Computer”. Click on the USB Memory Stick and then
click on the “WL400 (+Pro) Drivers” folder. Finally run the
Setup.Exe program by double clicking on it – see Figure
13.
When the Setup program runs you will see the initial window shown in Figure 14. Click the “Next” Button and you will see
the progress bar window in Figure 15. Once everything has been installed, you will see the Wizard Complete window in
Figure 16. Click the “Finish” button to complete the installation.
Figure 12
Figure 11
Figure 13
Figure 14
Figure 16
Figure 15
