Quick Start Guide
Rev: 10/21
Copyright © Digital Watchdog. All rights reserved.
Specifications and pricing are subject to change without notice.
INSTALLATION
Mounting point
Compatible wall mount
Mounting size
Mounting holes labeled 1
DWC-P230WMW
4.01” x 5.59” (102x142mm)
Mounting holes labeled 2
DWC-PZWM
4.13” x 4.33” (105x110mm)
Mounting holes labeled 3
DWC-WMJUNCW
Ø 4.76” (Ø 121mm)
Mounting holes labeled 4 All other dome camera wall mount
brackets
Ø 4.76” (Ø 121mm)
Mounting holes labeled 5 DWC-BLJUNC(-W), DWC-PBJUNC,
DWC-B7JUNC
Ø 3.07” (Ø 78mm)
1
Position the pole-mount in the desired location on the pole. The pole’s max width
should be no more than 470mm (the max length of the steel band).
2
Attach the mount firmly to the pole using a steel bands included.
3
Starting from the point where the pole-mount bracket will be attached, measure the
circumference of the pole. Some poles will taper with their height, so if the pole is
tapered, be sure to adapt the band lengths to fit.
4
Feed the included steel bands through the slots in the pole bracket.
5
Tighten the clamp on the steel band using a Phillips screwdriver. When the clamp is
tightened, check that the end of the band is held in place against the pole.
6
Bend the band and the clamp to a 90º angle to secure the free end of the remaining
length of metal band.
7
Use the table below to pair your wall mount or junction box with the appropriate set
of mounting holes.
Pole mount front view
DWC-P230WMW wall mount
bracket for PTZ IP cameras
MOUNTING HOLES #1
DWC-WMJUNCW junction box
for wall mount brackets
MOUNTING HOLES #3
DWC-BLJUNC-W and
DWC-PBJUNC junction
boxes for bullet cameras
MOUNTING HOLES #5
DWC-BLJUNC-W and DWC-PBJUNC
junction boxes for bullet cameras
MOUNTING HOLES #2
All other dome camera
wall mount brackets
MOUNTING HOLES #4
