D&N MODE
OSD Menu_Day & Night
1
MODE
1. AUTO : The camera will switch between color and B/W based on the AGC levels.
- CDS Threshold : Marks the light level at which the camera will switch between color and B/W.
The lower the value, the camera will require less light (more darkness) to switch to Night
Mode.
- CDS Margin : The value added to the CDS Threshold. Adjust this based on the environment
in which the camera is installed. If the margin is too low, the camera will switch from color to
B/W and back.
- EXT. LED : If set to AUTO: the LEDs are enabled/ disabled by the CDS Sensor on the LED
Board. If disabled, the camera’s LEDs are disabled manually.
- DELAY : Set the time interval delay before switching from day mode to night mode.
- SMART IR : Enable Smart IR and set the level. Higher values will make Smart IR stronger.
2. COLOR : The camera will remain in COLOR mode regardless of the lighting environment.
3. B/W : The camera will remain in B/W mode regardless of the lighting environment.
DAY / NIGHT
MODE
CDS THRES
CDS MARGIN
EXIT JUMP
AUTO
3
5
1
D&N
Day & Night Setup menu is available on the 2nd sensor only. Setting adjusted in the 2nd sensor will be
applied to the 1st and 3rd sensor.
EXPO
MOTI
PRIV
RGB
D&N
FUNC
SET
EXIT