Specifications subject to change without notice
© Digital View Ltd – Ver 1.5 7 May 2020 (DT-1920-HDMI-EDPT_manual.doc)
Page 5 of 33
•
••
•
Controller Mounting
: It is recommended that a clearance of at least 10mm is provided above and 5mm below the controller
when mounted. Additionally consideration should be given to:
•
Electrical insulation.
•
Grounding.
•
EMI shielding.
•
Cable management. Note: It is important to keep panel signal cables apart from the inverter & backlight cables to prevent
signal interference.
•
Heat & Ventilation: Heat generated from other sources, for example the backlight of a very high brightness panel may
generate significant heat which could adversely affect the controller.
•
Other issues that may affect safety or performance.
•
••
•
PC Graphics Output
: A few guidelines:
•
Signal quality is very important, if there is noise or instability in the PC graphics output this may result in visible noise on the
display.
•
Refer to graphics modes table in specifications section for supported modes.
•
Non-interlaced & interlaced video input is acceptable.
IMPORTANT: Please read the Application Notes section for more information.
