Digital Projection TITAN LASER WUXGA, Инструкция по установке и быстрому запуску, Страница: 79 / 137

Using the projector Digital Projection Ltd. Titan Laser WUXGA
Setup
Infrared Remote
IR Code
IR Code Reset
Memory
OSD Settings

On
0


Trigger-2 Off
Trigger-1 Off
Standby Period
Instant Startup Off
30 Min.
EDID Mode


Trigger-1 and Trigger-2
are not available with
input HDMI 3 or HDMI 4. If
you turn the remote
control off, you can only
turn it back on again from
the control panel or via the
Projector Controller
application.
The Projector Controller
software is available for
download from the Digital
Projection website, free of
charge.
A wired remote control will
also be disabled if
Infrared Remote is set to
Off .
l
Trigger1 and Trigger 2
Choose from Screen, 5:4, 4:3, 16:10, 16:9, 1.88, 2.35, TheaterScope, Source, Unscaled or RS232 to
determine what will cause each trigger output to activate.
l
Infrared Remote
Set to Off if you wish to disable the remote control.
l
IR Code
The projector and the remote control need a matching IR code: a two-digit number between 00 and 99 .
The default IR code is 00 . This is also a master code, which, if assigned to a remote, will work regardless
of the value assigned to the projector.
l
To assign an IR code for the projector: Select IR code. Use the UP and DOWN arrow buttons to
change the values.
l
To assign an IR code for the remote , press and hold the ADDR button on the remote until the
On indicator starts flashing. Release the ADDR button and while the indicator is still flashing,
enter a two digit address using the numeric input buttons. The indicator will flash three times
quickly to confirm the change.
l
IR Code Reset
Use this command to unassign an IR code from the projector. This will revert the IR Code value to 00.
To unassign an IR code from the remote control , press and hold ALT and ADDR simultaneously until
the On indicator flashes to confirm the change.
l
OSD Settings
Access this submenu to adjust the appearance and position of the on-screen display.
l
Memory
Access this submenu to save up to four presets containing custom combinations of image settings, or to recall a saved preset.
l
Instant Startup
When ON only the Laser will be turned off when the Power off command is given. A subsequent Power On will turn on the laser giving an apparent very fast
power on.
l
Standby Period
Used with Instant Startup. If Instant Startup in ON and the projector is powered down then the projector will go to Standby after the selected “Standby Period”
30 minutes, 60 minutes, 90 minutes.
l
EDID Mode
Access this submenu to set the frame rate and display resolution for each input type..
Highlight the UP arrow at the top of the page and press ENTER/OK to go back to the first Setup menu page. Highlight the DOWN arrow at the bottom of the page
and press ENTER/OK to navigate to the third Setup menu page.
Operating Guide
Rev A January 2019
page 79
Notes