Digital Projection
M-Vision LED+IR series
A TOUR OF THE MENUS
Operating Guide
Page Op_15
Rev D July 2014
Notes
See also
Using the Menus
, earlier
in this guide and
Menu Map
, later in
this guide.
The
Lighting Mode
will not change
until the menu has been turned off.
Anti-Blur
will increase the black
time between frames, to reduce
any blurring effect from fast moving
images.
Note
: This will decrease the
perceived brightness of the image.
Setup Menu
Lighting Mode
•
Set this to
Daylight
to set the projected output to
RGB
only.
•
Set this to
Night
to set the projected output to
Infra-Red
only.
•
Set this to
Custom
to enable the
RGB Dimming
and
IR Dimming controls
, for a combination of the two outputs.
Anti-Blur
•
Select from
Off
,
10mS
and
8mS
.
Auto Power Off
•
Set this to
On
, if you want the projector to go into
Standby mode
when no input source is detected for 20 minutes.
Auto Power On
•
Set this to
On
, if you want the projector to start up imediately when the mains is connected.
•
Set this to
Off
, if you want the projector to go into
Standby mode
when the mains is connected. In this case, the projector will not start up
until the
POWER
button is pressed on the control panel or the remote control.
