Digital Projection E-Vision Laser 15000 Series, Инструкция по установке и быстрому запуску

Страница: 19 / 145

Laser Safety Precautions Digital Projection E-Vision Laser 15000 Series
Laser Safety Precautions
See Product labels on page 110 for
details about the labels that are
located on the projector.
Warning! Death or Serious Injury could occur if the following precautions are ignored
Permanent/Temporary Blindness Hazard
Not for household use.
Class 1 RG3 Laser Product. No direct exposure to the beam shall be permitted, RG3 IEC 62471-5:2015.
Operators shall control access to the beam within the hazard distance or install the product at a height that will prevent exposure of the spectator’s
eyes within the hazard distance.
The product should be installed and operated in accordance with the provisions of IEC 62471-5:2015 and the Important Information document or
User Manual by instructed and skilled persons only (IEC 62368-1:2020).
Caution – use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation
exposure.
Lens Change should only be carried out by instructed and skilled persons in accordance with the Important Information document or User Manual.
If in doubt consult your dealer.
Ensure the projector is switched off and AC power removed before attempting a lens change
Do not attempt to operate the product without covers in place.
This product (MLS) has a built in Class 4 laser module. Do not attempt to disassemble or modify the laser module.
Do not look directly into the lens when the light source is on. The high brightness can cause permanent eye damage.
Introduction
Rev B April 2021
page 19
Notes