Digital Projection E-Vision Laser 5100 Series
Installation Precautions
Minimum 500mm
(19.69in)
Minimum 500mm
(19.69in)
Minimum 500mm
(19.69in)
Minimum 100mm
(3.94in)
Minimum 500mm
(19.69in)
Minimum 300mm
(11.81in)
Example Positioning
Make sure the lens cap is removed from the lens before operating the projector.
Light energy levels have been known to cause damage to both the lens and
projector optics. This damage is not covered by our warranty.
Connect the LAN cable only to a computer LAN connection. Other similar
connectors may have a dangerously high voltage source.
A VGA IN connector should be used to connect to the VGA IN port on the projector.
It should be inserted tightly, with the screws on both sides securely fastened to
ensure proper connection of the signal wire for achieving optimal display effect.
An AUDIO IN connector should be used to connect to the AUDIO IN port on the
projector. It CANNOT be connected to AUDIO OUT otherwise, it will lead to mute
output and even DAMAGE the port.
The power cord and signal cable should be connected before the projector is
powered on. During startup and operation, DO NOT insert or remove the signal
cable or the power cord to avoid damaging the projector.
Turn on High Fan Speed Mode when located in high altitude areas.
Rev B September 2020
page 14
Important Information
