Digital Equipment Pro-face PS-3450A Series, Справочное руководство, Страница: 31 / 103

PS-345XA Reference Manual
2-8
Summary screen
Specifies whether the configuration information of the running system is displayed. Select from [Enabled] or
[Disabled]. The factory default setting is [Disabled].
QuickBoot Mode
Specifies whether the system boot-up should be “QuickBoot mode”. When the choice is [Disabled], it will
execute a system test at the system boot-up. The factory default setting is [Enabled].
Extended Memory Testing
Specifies whether a test for the Extended Memory needs to be executed at the system boot-up. The test types
are listed below. The factory default setting is [Just Zero it].
[Normal] Normal test
[Just Zero it] Simple test
[None] No test
Show CMOS Checksum Error
Specifies whether an error message should be displayed when a CMOS checksum error occurs. Select from
[Enabled] or [Disabled]. The factory default setting is [Disabled].
Power On Delay
Specifies whether the system waits during boot-up. Select from [Enabled] or [Disabled]. When [Enabled] is
selected, the system waits about 4 seconds during boot-up. The factory default setting is [Disabled].
• If a USB device such as USB memory is connected to the PS-A when the PS-A is started, the fol-
lowing phenomenon may occur, depending on the device:
• It takes about 1 minute before the OS starts up.
• The PS-A does not recognize the USB device.
These problems may be solved by setting [Power On Delay] to [Enable].