Digital Equipment LA400, Руководство по обслуживанию

Страница: 65 / 127

Maintenance Manual Removal and Replacement
____________________________________________________________________________________________
4.3.10 AGA Motor
1) Remove the Main Rear and Front Covers (refer to chapter 4.3.4 and 4.3.5)
2) Unscrew the two screws securing the AGA motor on the mechanical assy.
3) Unplug the AGA motor connector from the main board and extract the cable from its
cable retainers located on the rear part of the mechanical assy.
4) Remove the AGA motor assy.
Replace the AGA motor following the above instructions in reverse order.
NOTICE : Before tighteing the motor screws, verify the correct and free movement of
the AGA gears.
Run the AGA calibration procedure to verify the correct AGA marker position.
Figure 4.10 AGA Motor
____________________________________________________________________________________________
LA400 Multiprinter 4. 13 ER-LA400-SV