DSP2022-A ATA/IDE Disk Drive Installation Guide
7
Select Single or Dual Drive Operation
With jumper 0 in place, your drive is set for single drive
operation, or as the master drive in dual drive operation.
If you wish to use this drive as the slave drive (drive D) in
dual drive operation, then remove jumper 0.
Remove Jumper 7
Remove jumper 7 to prevent the drive from entering
manufacturing test mode if pin A1 is grounded.
Obtain a mounting kit
Due to the large number of possible installation cabinets
and slot sizes, your drive does not come with an installation
kit of brackets, screws, and cables. You must obtain the
parts needed for your particular installation from your
distributor or purchasing source.
