Operation
Use the following procedure for file transfers using the Telnet protocol:
1.
Ensure that Break is set to LOCAL. Use the SHOW PORT command to
determine this. Use the SET PORT BREAK LOCAL command to set Break
to LOCAL, if needed. The LOCAL setting is the factory default.
2.
CONNECT to the file transfer partner.
3.
Press Break.
4.
Issue the command SET SESSION Telnet CLIENT PROFILE BINARY. Note
that in-band flow control (XON/XOFF) is disabled during file transfers using
Telnet.
5.
Run the file transfer program.
6.
When the file transfer is finished, press Break.
7.
Use the command SET SESSION Telnet CLIENT PROFILE CHARACTER to
enable terminal emulation.
Operation 4–7