Digital Equipment DECserver 90M, Руководство пользователя

Страница: 20 / 48

2–2 DECserver 90M Owner’s Manual
2.1.1 Standalone Installation
Depending on your configuration, you can install the DECserver 90M
as a tabletop device or on a wall by performing the following steps:
Wallmount Only:
1. Remove the back cover (refer to Figure 2–1).
a. Insert a small screwdriver into the top mounting hole of the cover.
b. Lift up the latch on the back cover of the unit.
c. Pull the top of the cover away from the unit and down to remove it.
2. Use the back cover as a template and position each of the #8 1-inch mounting
screws (not supplied).
3. Secure the mounting screws.
4. Replace the back cover on the unit.
Tabletop and Wallmount:
5. Connect the DECserver 90M BNC connector to a properly configured Thin-
Wire network as shown in Figure 2–2.
or
Connect the 10BaseT connector to a properly configured 10BaseT network as
shown in Figure 2–3.
CAUTION
You should choose only a ThinWire or 10BaseT con-
nection. If you connect to both, the connection will not
function properly.