Digital Equipment CELEBRIS XL, Руководство по техническому обслуживанию

Страница: 20 / 110

Utilities & C onfiguration D igital C ELEBRIS X L & X L
D P
PC
20 M C S Logistics Engineering - N ijm egen
C
E
L
E
B
R
S
X
L
Upgrading the BIOS to a New Language
Perform the following steps to upgrade the BIOS to a new language:
1) Turn on the computer and allow POST to complete.
If POST detects an error refer to Chapter 4, “Troubleshooting” and take the appropriate steps to
correct the problem. After the problem has been resolved, restart the computer.
2) Insert the multilingual BIOS diskette into drive A.
3) At the DOS prompt, type: \phlash**
where ** represents the appropriate BIOS language as follows:
GR German
FR French
IT Italian
EN English
For example, to switch to a Spanish BIOS enter: \phlashSP
A screen appears on the monitor warning that you are about to erase the BIOS.
4) Press [Enter] to continue. Else, press [Esc] to cancel.
When pressing [Enter], PHLASH.EXE automatically updates the BIOS.
After the flashing process completes, the computer automatically reboots itself so changes
immediately take effect.
5) Remove the multilingual BIOS diskette.
Using EPP3NS.EXE to Configure an EPP Parallel Port
EPP3NS.EXE is a device driver for configuring the parallel port as an enhanced parallel port (EPP).
Before loading this device driver, check the documentation for the device to be connected to the parallel
port and make sure it supports EPP mode. If it does not, there is no need to load this device driver.
If the device does support EPP mode, perform the following:
1) Either copy EPP3NS.EXE to the hard disk drive or locate it on the hard disk drive’s factory installed
software (Note the path where the driver is located).
2) Edit the CONFIG.SYS file to enter the path for EPP3NS.EXE.
Refer to the DOS documentation for information on editing the CONFIG.SYS file. For example a
line in the CONFIG.SYS might be: device=C:\epp3ns.exe
3) Save the new version of the CONFIG.SYS file.
4) Press [Ctrl] + [Alt] + [Del] to reboot the computer.
5) Before POST completes, press [F2] to enter Setup.
6) Choose the Advanced Menu in Setup and select Parallel Port Mode.
7) Choose EPP mode.
8) Select Save Changes and Exit to save the new setting.
The computer will then automatically reboot.
The parallel port is now configured as an EPP port.