Digital Check QUANTUM DS QDS20012-SYS, Инструкция по установке и эксплуатации, Страница: 19 / 44

Operating the unit
2-9
82275345-003
Prepare items properly for flow to prevent or minimize document stops in the track. See
“Document Preparation” earlier in this section.
If there are repeated problems with documents moving through the track, see Section 5 of this
guide, “Jams or Unexpected Paper Stops.”
If a document stop or exception condition occurs, the Exception Handler will pop up on the
track controller
screen. Follow the Exception Handler’s instruction to clear the exception.
Clearing Stopped Items in Track
When an item stops in the track, there are two methods to clear the track:

Use the Start/Stop button to move the item to a pocket

Manually remove the item from the track.
Using the Start/Stop Button to Move Stopped Items
to a Pocket
You should first try to flush the stopped item from the track using the Start/Stop button .
1.
Press and hold down the Start/Stop button for three (3) seconds to move
the item through the track to the pocket(s). Leave the items in the pocket(s)
once the track is cleared.
Note: Start/Stop Button functions are dependent on your application. Refer to
your application instructions.
Start/Stop Button
2.
If an item remains in the track after holding down the Start/Stop button for
three seconds, you must manually remove the item from the track. You
should be able to remove the stopped items without removing the covers.
Whether you remove covers or not, keep items in the same order in which
they were inserted for processing.
Manually Removing Stopped Items from the Track