LIVEMIX DA-816
7
SETUP AND OPERATION
The DA-816 output box allows users to send their personal mixes to wireless in-ear transmitters,
powered monitors, or powered house speakers. The DA-816 connects to the MIX-16/MIX-32 via
a shielded CAT5e/CAT6 network cable. Each DA-816 provides eight stereo outputs. Any Livemix
personal mix can be assigned to one or more of these eight stereo outputs.
CONNECTING A SINGLE DA-816 TO A MIX-16/
MIX-32
1. Attach the 12VDC external power supply to the DA-816
external power supply connector.
2. Insert a shielded CAT5e/CAT6 network cable into the
LIVEMIX DATA OUT 1 on the MIX-16/MIX-32.
3. Connect the other end of the network cable to the
LIVEMIX DATA IN port on the DA-816.
CONNECTING TWO DA-816 UNITS TO A MIX-32
For installations that require more than 8 stereo outputs, use the MIX-32 with two DA-816 units for
up to 16 stereo outputs.
1. Attach the 12VDC external power supply to the DA-816
external power supply connector.
2. Connect the first DA-816 as described above.
3. Insert a second shielded CAT5e/CAT6 network cable into
the LIVEMIX DATA OUT 2 on the MIX-32.
4. Connect the other end of the network cable to the
LIVEMIX DATA IN port on the
second
DA-816.
CONNECTING THE TRS OUTPUTS TO AN
EXTERNAL DEVICE
The DA-816 analog outputs can send any Livemix personal mix to any external balanced analog
input. Most often this will be a wireless in-ear monitor system. The DA-816 outputs are labeled 1-8
corresponding to the 8 outputs on DA-816 SoftRoute™ screen
on the Livemix personal mixer (see below).
1. The TRS connectors on the back of the DA-816 are labeled
to correspond with the assignable outputs. Connect
balanced TRS cables from the desired output to the
external device.
2. Use SoftRoute™ on the Livemix personal mixer
touchscreen to assign mixes to the outputs.
NOTE:
If you are using a MIX-32 and
a single DA-816, it MUST be
connected to LIVEMIX DATA
OUT 1. Connecting to LIVEMIX
DATA OUT 2 will not function
properly.
NOTE:
When using two DA-816s with
the MIX-32, you can assign any
of the available Livemix mixes
to any of the DA-816 output
ports. All of the available mixes
will be available on both the
LIVEMIX DATA OUT ports.
NOTE:
For external devices that only
have mono inputs, change
the Livemix mix output to
BALANCED MONO mode after
assigning the mixes. This will
send the same mono signal
out of both TRS jacks for the
assigned output.
