4. Home/Office Installation
Review pre-installation considerations and determine site installation plan.
1. Install supplied outside antenna (P/N 288-PB) to vertical surface or pole with
supplied hardware. Mount the outside antenna clear of metal objects and
obstructions. Outside antenna must be mounted in a vertical position.
WARNING!
Only Digital Antenna authorized products may be used with the
DA4000SBR system. Using unauthorized equipment will harm the
DA4000SBR system, can be detected and voids the warranty.
2. On supplied 30’ cable (P/N C277-30) (or optional 50’ and 75’
PowerMax
TM
cables) attach N male connector to N female connector on outside antenna. Secure
cable to the side of the building with appropriate fasteners (not supplied). Route
cable according to site installation plan to the DA4000SBR unit.
3. Attach mini-UHF male connector at the end of the supplied 30’ cable to
DA4000SBR unit on the port labeled outside antenna. Attach the 18” cable
attached to the inside antenna and stand to the port labeled inside antenna. The
inside antenna must be operated in a vertical position.
4. The DA4000SBR unit has four mounting holes that can be fastened to a secure
surface. (fastening hardware not included) When mounting the DA4000SBR unit
the inside antenna must be in a vertical position.
5. Plug 100-240VAC power supply to the DA4000SBR unit. Plug the other end into
standard household 110VAC receptacle.
6. Turn the power switch to ON. If the light on the DA4000SBR unit is green then
the DA4000SBR system is operating. Test the amplifier/repeater system by
making a cell call and verifying that the indicator light does not turn red. If the
light on the DA4000SBR unit turns red immediately turn OFF the DA4000SBR
unit and refer to the Amplifier/Repeater status section.
Coverage Area
indicated by yellow
Amplifier/Repeater
Unit
8
