R232 / R232-48VDC Installation Guide
Page 5 of 8
The R232 ships with a right-angle IEC power cable similar to
the one shown on the right.
The plug is inserted in the AC receptacle on in the Pocket
Power Supply opening and the wire is routed along the cable
management tray as shown in Figure 5.
Figure 5: R232 side view with AC power cord installed and properly configured.
2.1.2 R232-48VDC Power Connections - DC
The model R232-48VDC uses a different connector in the Pocket Power Supply
opening. This connector is a two-pin removeable terminal block where one side
remains mounted to the chassis as shown in Figure 6, while the mating connector
can be easily removed to facilitate installation of the power cabling.
IMPORTANT NOTE:
CLOSELY OBSERVE THE CONNECTION POLARITY TO AVOID DAMAGE!
Figure 6: R232-48VDC Pocket Power Supply with removeable terminal receptacle for DC input
(shown with mating connector removed)
Along the same side of the chassis is the power cable management tray which
allows the power cable to be cleanly supported toward the rear of the chassis.
The R232-48VDC is not supplied with any power wiring. This is the sole
responsibility of the customer. The terminal strip can accept wires up to 16 gauge.
Pocket Power Supply
TM
opening
Power cable management tray
Power cable routed to chassis rear
Power cable inserted in AC receptacle
