Digital Acoustics INT-IP-2Gang
Installation and SIP Configuration
Page 3 of 3
Select the
SIP Settings
tab
•
Press the
Apply Defaults
button on the bottom right to copy in the
default SIP information that was previously setup
•
Enter the
SIP Extension
,
SIP Password
(also known as the
Secret
)
that have been setup on the SIP based phone system for this IP7
device
•
In the
SIP Authentication
(also known as the
SIP Authorization
Name
), enter the User that has been associated with this extension in
the SIP based phone system. If no User has been setup, use the
same value as the SIP Extension
•
Check the
Full Duplex
option to enable full duplex operation or leave
it blank for of half duplex
o
In a half-duplex phone call, one party has their microphone active
while the other party has their speaker active. By default, when a
call is initiated, the INT-IP-2Gang starts with the speaker active
and the phone operator starts their microphone active. The
phone operator can toggle the modes by pressing 0 on the
phone’s keypad. In half duplex mode, the INT-IP-2Gang volume
will always be louder, and the microphone gain will always be
higher
o
In full duplex mode, both parties have their speaker and
microphone active at the same time. In full duplex mode, the INT-
IP-2Gang volume will always be softer, and the microphone gain
will always be lower. This is due to the algorithms used by the IP7
for echo cancellation
•
Check the
Outdial Extension
and enter the number to be automatically dialed when the integrated Call button is
pressed
•
If the integrated relay will be used to open a door during a call, specify a 1
– 4 digit code in the
Door Open Code
to be
entered on the phone’s keypad. If the specified code has multiple digits, the phone operator will need to enter a # after
the code (using this example, phone operator would need to enter the digits 65# during the call to activate the relay). If
only a single digit is specified, the phone operator only needs to enter that digit.
Select the
Advanced Settings
tab
•
Click the
Set
button next to
Audio Profile
and
s
elect the
INT-IP-
2Gang
audio profile if using full duplex. Otherwise select the
Half
Duplex
audio profile
•
Click the
Save Settings
button. The endpoint will reboot with the
changes and register with the SIP Server within 30 seconds. The red
Call button LED on the panel will blink rapidly for 30 seconds and
then turn solid
•
There are 7 volume steps that will vary based on whether full or half
duplex has been configured. Volume can be adjusted when a SIP
call is in progress by pressing:
o
#00
– Set volume down one level
o
#01
– Set volume level to 1
o
#02
– Set volume level to 2
o
#03
– Set volume level to 3
o
#04
– Set volume level to 4
o
#05
– Set volume level to 5
o
#06
– Set volume level to 6
o
#07
– Set volume level to 7
o
#08
– Set volume up one level
•
For Full Duplex, the volume level should be set to 4 or 5 for best results
IP7 and Digital Acoustics® are trademarks of Digital Acoustics LLC.
Other trademarks are the property of their respective owners.
All Rights Reserved ©2019