Digisol DG-GS4826S, Руководство по управлению

Страница: 529 / 1344

C
HAPTER
20 | IP Services
Dynamic Host Configuration Protocol
– 529 –
C
OMMAND
U
SAGE
u
First configure address pools for the network interfaces. Then you can
manually bind an address to a specific client if required. However, note
that any static host address must fall within the range of an existing
network address pool. You can configure up to 8 network address pools,
and up to 32 manually bound host address pools (i.e., one address per
host pool). Just note that any address specified in a host address pool
must fall within the range of a configured network address pool.
u
When a client request is received, the switch first checks for a network
address pool matching the gateway where the request originated (i.e.,
if the request was forwarded by a relay server). If there is no gateway
in the client request (i.e., the request was not forwarded by a relay
server), the switch searches for a network pool matching the interface
through which the client request was received. It then searches for a
manually configured host address that falls within the matching
network pool. If no manually configured host address is found, it
assigns an address from the matching network address pool. However,
if no matching address pool is found the request is ignored.
u
When searching for a manual binding, the switch compares the client
identifier and then the hardware address for DHCP clients. Since BOOTP
clients cannot transmit a client identifier, you must configure a
hardware address for this host type. If no manual binding has been
specified for a host entry with a hardware address or client identifier,
the switch will assign an address from the first matching network pool.
u
If the subnet mask is not specified for network or host address pools,
the class A, B, or C natural mask is used (see "Specifying Network
Interfaces" on page 545 ). The DHCP server assumes that all host
addresses are available. You can exclude subsets of the address space
by using the IP Service > DHCP > Server (Configure Excluded
Addresses – Add) page.
P
ARAMETERS
These parameters are displayed in the web interface:
Creating a New Address Pool
u
Pool Name – A string or integer. (Range: 1-8 characters)
u
Type – Sets the address pool type to Network or Host.
Setting Parameters for a Network Pool
u
IP – The IP address of the DHCP address pool.
u
Subnet Mask – The bit combination that identifies the network (or
subnet) and the host portion of the DHCP address pool.
Setting Parameters for a Static Host
u
IP – The IP address to assign to the host.
u
Subnet Mask – Specifies the network mask of the client.