Tighten the screws using the phillips head screw driver.
Do not over tighten.
Installation
For illustration, a standard body, keypad lock with a bolt rear unit is used.
Make sure the connector pins align properly with the
connector.
If properly connected, a triple beep will be heard and
the LED will flash three times.
Insert the front unit nut posts through the door mounting
holes.
Hold the front unit against the front of the door. Use
the screws of the rear unit as a guide then slide the
front and rear units together.
Connect the pin extender to the rear unit.
Place the split lock washers on the phillips head screws
and insert them through the rear unit mounting holes.
14
1
3
2
5
4
6
