Digikeijs DR5088RC DIGIDETECT, Руководство пользователя

Страница: 24 / 43

DR5088RC DIGIDETECT
30.05.2019
P 24
www.digikeijs.com
1
2
3
5
8
1. Digitrax® specification for reporting 'short' locomotive addresses.
Standard: Report 0x7D in high quality byte.
Alternative: Report 0x00 in high quality byte.
2. Block addresses are sent by Digitrax® only in even numbers. However,
the DR5013 can also send linear (even and odd) block addresses, ex-
tending the reporting range by 2048.
3. Report the speed of the locomotives to the control centre via Rail-
com®.
4. To prevent too many messages from being sent to the central unit
when the value changes quickly, a "Delta" value can be set here.
(*See example)
5. Report the signal quality of the Railcom® messages to the control cen-
tre.
The messages are reported by the decoder in %.
0% All commands have arrived (track or locomotive clean).
100% of the commands have not arrived (track or locomotive
dirty).
4.4.2 Module Properties
6
7
6. All QoS messages below this value are not reported to the central
unit.
7. A "Delta" value can be set here so that too many messages are not
sent to the central unit when the value changes quickly.
8. „"Report the "tank contents" of the locomotives to the central unit via
Railcom®.
* Example:
1. last measured value =10
newly measured value =6 Delta = 4
2. last measured value =3
newly measured value =9 Delta = 6
3. last measured value =12
newly measured value =1 Delta = 11
Parameter "Delta" = 6 The values 2. and 3. are reported, 1. is suppressed.
Notice! Not all functions are supported by all decoders. Please refer to the
respective decoder manual for details.
4