32
9RLFH*$7(*$7(:$<XVHUPDQXDO
- seizure: line seizure mode.
None (0)
Æ
when calling from IP side, choose L1 every time if it is
available.
UCD (1)
Æ
when calls from IP side, choose L1 for the first time, and L2
for the 2
nd
time, (cyclic)
1RWH
: Do not enable this function together with
JURXS
(please refer to 5.18).
- 2nddial: This command is necessary for setting one time dial method use.
While user would like to skip 2nddial process, VoiceGATE GATEWAY
must close 2nddial and set as 0 (2nddial off). The default value is set
as 1 (2nddial on).
- drule: This command only works while 2nddial is off. When user would like to
make an outgoing call or receive an incoming call shortly, it is
necessary to set the following three commands belonged to drule.
drop: drop the dial digit.
insert: insert the dial digit
filter: filter the dial digit.
1RWH
1. out: Through VoiceGATE GATEWAY to dial out to another Gateway’s e164
number. When making an outgoing call, it is necessary to set three
commands in order, filter, insert then drop.
Example: sysconf –drule out_filter 002886 out_insert 0 out_drop 02
2. in: Through pass VoiceGATE GATEWAY in order to connect with PSTN /
PBX side. When making an incoming call from other Gateway, the three
commands is necessary to be set in order, drop, insert, then filter.
Example: sysconf –drule in_drop 002886 in_insert 0 in_filter 02
3. While the specified digit would like to be deleted, use the character x
instead of any digits have configured.
-askpin:
0
Æ
disables ASKPIN function
1
Æ
enables ASKPIN function, and apply to the whole unit. Every
channel uses the same PINCODE.
2.
Æ
enables ASKPIN function, and apply to each channel
respectively. Every channel uses a different pincode.
-ring: To set when dial in VoiceGATE GATEWAY from PSTN side,
VoiceGATE GATEWAY will pick the call immediately or rings for
specific times before picks up.
0
Æ
disable: pick up immediately
1-5
Æ
times of ring before VoiceGATE GATEWAY picks up.
- callalive: Call Alive function (1 = ON; 0 = OFF). The function is used to check
if the opposite party is alive when connection is established. When
CallAlive is activated, VoiceGATE GATEWAY will send H.245
RoundTripDelay message to other party, and wait for response. If the
other party cannot respond the message in 10 seconds, VoiceGATE
GATEWAY will regard the opposite party as IDLE state and
disconnect the call. When CallAlive is deactivated, RoundTripDelay
message will not be sent during connection.
