31
9RLFH*$7(*$7(:$<XVHUPDQXDO
to make a 2
nd
dial to destination.
1
Æ
Direct In Line Service(this feature must be implemented in a pair of
FXO products in Gatekeeper mode and set bureau –table command)
In Direct In Line Service VoiceGATE GATEWAY will connected via
gatekeeper to pre-defined E.164 number.
For example:
EXUHDX±WDEOH
SOHDVHUHIHUWREXUHDXFRPPDQG
If L1 of VoiceGATE GATEWAY is assigned to pre-defined E.164
number 123 in Direct in line mode. When users from PSTN make a
call to L1 of VoiceGATE GATEWAY, it will sent out the number 123 to
GK, and GK will route this number to the endpoint which registered
E.164 is 123 without 2
nd
dial.
1RWH ,Q 'LUHFW ,Q /LQH VHUYLFH PXVW VHW 9RLFH*$7( *$7(:$<
V\VFRQI±QGGLDO
2
Æ
HotLine/ LineToLine Service (this feature must be implemented in
a pair of FXO products in P2P mode and set bureau –table
command)
HotLine Service provides Hot Line function, which connects directly
to pre-defined destination. For ex: if L1 of VoiceGATE GATEWAY is
assigned to destination address 192.168.1.12 in Hot Line Mode.
When users from PSTN make a call to L1 of VoiceGATE GATEWAY,
it will directly connect to 192.168.1.12 without a 2
nd
dial.
1RWH ,Q KRWOLQH VHUYLFH PXVW VHW 9RLFH*$7( *$7(:$<
V\VFRQI±QGGLDO
LineToLine Service is like HotLine Service, but ask for a specific line
number. For ex: if L1 of VoiceGATE GATEWAY is assigned to
destination address 192.168.1.12 /Line4 in LineToLine Mode. When
users from PSTN make a call to L1 of VoiceGATE GATEWAY, it will
directly connect to 192.168.1.12 and choose Line4 to call out to
PSTN. This is mostly applied to ITSP, who provides international
VoIP solution.
1RWH ,Q /LQH7R/LQH VHUYLFH PXVW VHW 9RLFH*$7( *$7(:$<
V\VFRQI±QGGLDO
- ringdet: to define ring detection method. (0 is for old hardware version; 1 for
new hardware version)
- plan: It is for setting dial-numbering plan. While e164 number is three digits,
the plan should be set as 3 or 0. The plan 0 is for any positive digits
use.
- port: This command can enable or disable individual port. The default value
is set to enable all ports.
- idto: The duration of two pressed digits in dial mode
-
eod: Digit type of end of dialing. ( 0:No end of dialing, 1:[*] button,
2:[#]button )
