Digicom Pocket AL I/O, Руководство пользователя

Страница: 13 / 36

2.5
Pocket AL I/O Installation
2.1.7. Powering on for the first time
• Once the hardware installation is over it is necessary to configure Pocket AL I/O.
• At the first power on check the status of Power and Status led.
• After few seconds Pocket AL I/O will register to the GSM network and the Power led will start blinking; the Status led will give the
indication of the signal. In case Power led is fixed on or the Status led is off, power off Pocket AL I/O and verify as follows:
- the SIM is correctly inserted into the SIM slot;
- the PIN code request is disabled;
- the GSM quality signal (insert the SIM card itself in a mobile phone).
2.2. LED InDIcAtOrs
You can control the status of Pocket AL I/O through two leds:
LED STATUS DESCRIPTION
POWER
OFF Device off
ON Power on and search for network
BLINKING Device registered to the GSM network
SLOW BLINKING Device powered by battery
STATUS
OFF Trouble condition: search for network, low GSM signal, no
SIM, PIN request or registration in Roaming (see command
#GSM#)
SLOW BLINKING Good GSM signal
FAST BLINKING Receiving SMS. 3 seconds sequence time
ON Sending SMS. 3 seconds sequence time
Note: in case the device is powered through a battery, the Power led will show this status (slow blinking);
refer to the Status led to control the registration status.
2.3. BAcK-UP BAttErY
The battery backup is placed into the product.
Back-up Battery features: Li-ion 3,7V – 950mAh rechargeable.
At the first power on, leave the device connected to the power supply for at least 5 hours for a correct and complete battery
charging.
You will have the best performance in battery autonomy after 2 or 3 cycles of complete charge and discharge.
2.3.1. Remove the back-up battery
The replacement of battery must be carried out by qualified staff in
our maintenance centre.
In special cases, to remove the battery disconnect the device from
the main power.
Open the device, removing the terminal board panel.
Disconnect the
connector as shown in picture.
Remove the board first, then you will be able to remove the
battery.