Digi TransPort LR54-AA401, Руководство пользователя

Страница: 119 / 169

Command descriptions
TransPort LR User Guide 166
ipsec-failover
Configures IPsec tunnel failover.
Syntax
ipsec-failover <1 - 10> <parameter> <value>
Parameters
state
Enables or disables the IPsec failover feature.
Value is either on or off. The default value is off.
from
The IPsec tunnel to failover from. Also known as the primary IPsec tunnel.
Accepted value is any integer from 1 to 32. The default value is 1.
to
The IPsec tunnel to failover to. Also known as the backup IPsec tunnel.
Accepted value is any integer from 1 to 32. The default value is 1.
timeout
The time, in seconds, once the primary interface has gone down, that the IPsec tunnel failover
feature should wait before attempting to failover to the backup IPsec tunnel.
Accepted value is any integer from 10 to 3600. The default value is 180.
probe-host
Probe this IPv4 device.
Value should be a fully qualified domain name.
probe-interval
The interval, in seconds, between sending probe packets.
Accepted value is any integer from 1 to 3600. The default value is 60.
probe-size
The size, in bytes, of the probe packet.
Accepted value is any integer from 64 to 1500. The default value is 64.
probe-timeout
The time to wait before a response to the probe packet.
Accepted value is any integer from 1 to 60. The default value is 1.
switch-primary-up
The time, in seconds, to wait after the primary IPsec tunnel comes up before switching back to it.
Accepted value is any integer from 0 to 3600. The default value is 0.