Digi MIL-120A Скачать руководство пользователя страница 4

 

Doc #: 75140  Rev. D

 

L e g a l

 

R e g u l a t o r y   A p p rova l s

 

FCC Class A

UL 1950

CSA 22 No. 950

EN60950

CE 
– EN55022 Class B
– EN50082-1

 

C a n a d i a n   E M I   N o t i c e

 

This Class A digital apparatus meets all the requirements of the Canadian Interference-Causing 
Equipment Regulations.

Cet appareil numérique de la classe A respecte toutes les exigences du Règlement sur le matériel 
brouilleur du Canada.

 

E u ro p e a n   N o t i c e

 

Products with the CE Marking comply with both the EMC Directive (89/336/EEC) and the Low Voltage 
Directive (73/23/EEC) issued by the commission of the European Community. Compliance with these 
directives implies conformity to the following European Norms:

EN55022 (CISPR 22) - Radio Frequency Interference

EN50082-1 (IEC801-2, IEC801-3, IEC801-4) - Electromagnetic Immunity

EN60950 (IEC950) - Product Safety

 

To   C o n t a c t   D i g i

 

For prompt response when calling for service information, have the following information ready:

Product serial number and rev.

Date of purchase

Vendor or place of purchase

Reach Digi Technical Support at 408/744-2751
Or E-mail at “[email protected]

 

Address: 1299 Orleans Drive

Sunnyvale, CA 94089

Voice:

408/744-2775 

Fax:

408/744-2793 

E-mail:

[email protected]

Five-Year Limited Warranty

Digi International warrants to the original consumer or purchaser that each of its 
products, and all components thereof, will be free from defects in material and/or 
workmanship for a period of five years from the original factory shipment date. Any 
warranty hereunder is extended to the original consumer or purchaser and is not 
assignable.

Digi makes no express or implied warranties including, but not limited to, any implied 
warranty of merchantability or fitness for a particular purpose, except as expressly set 
forth in this warranty. In no event shall Digi be liable for incidental or consequential 
damages, costs, or expenses arising out of or in connection with the performance of the 
product delivered hereunder. Digi will in no case cover damages arising out of the 
product being used in a negligent fashion or manner.

Содержание MIL-120A

Страница 1: ...g information Installation on page 2 Link Test on page 2 Disabling Link on page 2 Diagnostic LEDs on page 3 Configuration on page 3 RJ 45 Pinouts on page 3 Legal on page 4 12 20VAC Ethernet IEEE 802 3 FCC PART 15 CLASS A COMPLIANT THIN TWIST Model MIL 120A COAX to 10BaseT CONVERTER COL TP RCV TP LINK POWER COL CX RCV CX ...

Страница 2: ...he Link function test enabled only pin one jumpered with a jumper block This allows the LEDs to illuminate when there are links Disabling Link To disable the Link test 1 Use a Phillips head screwdriver to remove the four Phillips type screws located on the sides of the unit 2 Remove the BNC nut and its washer 3 Slide the housing off over the BNC connector 4 Locate the two pin Link jumper Figure 1 ...

Страница 3: ...lude If the MIL 120A is connected to the end of a multi node segment without a T connector and terminator enable the 50 ohm resistor by Placing switch 1 UP and Placing switch 2 DOWN If the MIL 120A is connected to a single node without a T type connector and terminator on a COAX cable of less than one meter s length Place both switches 1 and 2 in the DOWN position Note For this configuration you d...

Страница 4: ... serial number and rev Date of purchase Vendor or place of purchase Reach Digi Technical Support at 408 744 2751 Or E mail at sun tech dgii com Address 1299 Orleans Drive Sunnyvale CA 94089 Voice 408 744 2775 Fax 408 744 2793 E mail info dgii com Five Year Limited Warranty Digi International warrants to the original consumer or purchaser that each of its products and all components thereof will be...

Отзывы: