DR6400W Series Installation Guide
2
Safety Notices
1) Please read all instructions before installing and powering the unit. You should keep
these instructions in a safe place for future reference.
2) The DR6400W series use a 12V DC/1.5A power supply (mains adapter). If the mains
adapter shows signs of damage or malfunction, you should stop using it immediately
– turn off the power at the mains and disconnect it from the mains supply before
contacting your supplier for a repair or replacement.
3) Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment. Use only the
accessories, attachments, and power supplies provided by the manufacturer –
connecting non-approved antennas or power supplies may damage the unit, cause
interference or create an electric shock hazard, and will void your warranty.
4) Do not attempt to repair the products. They contain no electronic components that
can be serviced or replaced by the user. Any attempt to service or repair the unit by
the user will void the product warranty.
5) These products are designed for indoor use only and should be used in an
environment that is suitable for computers and other electronic equipment.
6) Ports that are capable of connecting to other apparatus are defined as SELV ports.
To ensure conformity with IEC60950 ensure that these ports are only connected to
ports of the same type on other apparatus.
Note on Wireless Networks
The wireless networks supported by the DR6400W series routers fall into two categories:
GSM networks and 3G networks. GSM networks support the GPRS and EDGE data
transmission standards whilst 3G networks support 3G (UMTS), HSDPA and HSUPA.
Throughout this manual these networks will be referred to as either GSM or 3G networks,
or simply as ‘wireless’ networks. The type of network supported depends on which
wireless option is purchased, either GSM or 3G.
Local WiFi wireless networking will be referred to as WiFi.
DR6400W Series Installation Guide
3
Preface
This guide describes the installation procedure for DR6400W series products. It is
intended to provide sufficient information for you to be able to connect the unit to your
terminal equipment and power supply. A complete reference guide to the software
features that are available on the product is available separately in PDF format that can
be downloaded from the Digi International website (
www.digi.com
).
The DR6400W features:
♦
4-port 10/100Base-T Ethernet switch
♦
1, 2 or 6 RS232 serial ports (depending on model)
♦
2 x USB 2.0 host ports
♦
ADSL2/2+/2++
♦
3G/HSDPA/HSUPA or GPRS/EDGE wireless options
♦
ISDN BRI or PSTN options
♦
802.11 b/g WiFi
