Digga TORQUE LOGIC, Руководство по установке

Страница: 9 / 12

9
PM-000121 Digga Torque Logic Installation Manual
CABLING CONTINUED
Attach the Pran Harness (provided) to the main cable. Make sure to
avoid pinch points when routing the Pran Harness inside the cab of
the machine.
Decide where to mount the Digga Torque Logic Display, which will
be convenient to the operator, close to a power source and avoid
excessive bumping or banging of the monitor.
Use the Ram Mount (provided) and attach it to the area inside the
cab that you have selected.
Tripple Suction Cup Ram Mount Single Suction Cup Ram Mount
E)
F)
G)
Attach the Pran Harness to the Digga Torque Logic Display, then the
Display to the Ram Mount. Ensure all connections are secure. (Note
the area at the back of the Digga Torque Logic Display screw hole
pattern to match the Ram Mount).
Do a final check outside the cab to ensure the Digga Torque Logic
and end cap are secured properly, and all cable connections are
tight, with cabling free and clear of pinch points
Important Note: The Pran Harness is equipped with battery back up in the event of
accidental disconnection, however it is not recommended for steady use.
Protect the Digga Torque Logic Display by carefully following the
recommendations below.
When using the display always use the on/off switch on the harness to control power.
Never disconnect the power by pulling the plug from the power source. This can result
in corruption of data stored in your Display.
Do not tap on the screen of the Digga Torque Logic Display with any object other than
your finger. Hard or pointed objects may damage the screen.
Never use fingers to align hood to linkage when installing or removing the Digga
Torque Logic.
WARNING
D)
C)