Digga PR3843, Руководство по установке, эксплуатации и устранению неисправностей, Страница: 14 / 32

Step 1
Attach the black harness to the back of the display and plug the other end into the cigarette lighter
in the machine, it must be plugged it at all times to work.
Step 2
Turn on the display the power button is located on the top left of the display.
Be sure when turning
it off you use the shutdown button located in the menu or on the top left side of the display, select
shutdown. Using the power button to turn off could cause the display to corrupt.
1. Hardwired version will
connect automatically.
NOTE: If you are using a Torq ue Hub or wireless pin be sure to fully charge the
battery inside the hub or wireless box before starting your job should be 16.5V
NOTE: Letting the cell reach OV can permanently reduce the CELL’S capacity.
Most protection cells are not designed to let the CELL be recharged after the
cell’s voltage is below OV.
*These will not be covered under warranty.*
Connect to Hub
1. T ouch on menu
14
Be sure when turning it off that you use the shutdown button: touch menu
then shutdown, wait approx. 2 mins before turning power switch off.
You must turn the switch off to be sure that when starting up again the display
does not get a power surge.
Using the power button to turn off the display before following the above
instructions could cause the electronics in the display to be corrupt.
*Doing this will void the warranty*
PM-000 199 September 20 19