→
7
Acknowledging an Overlimit Condition
When one of the functions of your instrument exceeds it’s set limit, the instrument
will display that function and flash the display. To return the instrument to the
function that was displayed before the overlimit condition, press any button. Your
engine may still be running over the set limit, but the instrument will not display
that condition after you press a button. If the function goes below the set limit
and then again exceeds the limit, the instrument will again display and flash the
over limit function.
Reset Lap and Event Number and Clear Memory
To reset the lap and event number to zero and clear all recorded data, press the
and the Max/Event buttons at the same time. When the display flashes PrS
PLA, press the Play/Pause button. Any recorded data is now cleared from your
instrument. Limits are not cleared. If you do not press the Play/Pause button
within 5 seconds the reset will be aborted.
Note: The memory is not automatically reset when you turn the instrument off.
All data is retained when the instrument is turned off and even when the batteries
are removed.
