20
→
→
→
Why does my instrument only record for 2 minutes?
Your instrument will record for longer than 2 minutes, but your display has a limit
to what it can show. The instrument has two resolution levels, high and low.
• To change the resolution of your display, press the and the buttons at
the same time, while in Monitor/Record mode.
• High resolution can display up to 1:59.9. The 1 on the left of the display
toggles every other minute.
• Low resolution can display up to 19:59. The 1 on the left of the display
toggles every 20 minutes.
Why does my display keep saying LooP?
This means that your instrument is searching for data, usually the beginning of
a lap during Playback.
Why does my lap number have a 1 in front of the L?
If your display shows 1L and two other numbers, it means that you have recorded
over 100 laps during the current Event.
Why is the colon ( : ) flashing?
This signifies that the clock is running, either during record or playback.
Why is the Display Flashing?
This signifies that you are either in Set Limits or that your engine exceeded a set
limit.
Why won’t my instrument record?
The instrument will not record if it is in Laps or Playback. (PRS is displayed on
the left side of the display). Press the
Exit/Power
button until PRS is no longer
displayed and then you can begin recording.
Why won’t my instrument respond when I press a button?
The computer in your instrument needs to be reset. It should still respond to the
Function
button. Press this button, then turn the instrument off for 30 seconds.
Turn the instrument back on and check to see if it is working properly. If it is not,
turn it off and on again. Immediately after turning it back on, press the and the
Max/Event
buttons to reset the instrument. When the display flashes PrS PLA,
press the
Play/Pause
button. If you had to reset the instrument, all of your
previously recorded data was erased, but it should now be working properly.
