6.2
Manual Channel Selection
The 3 channels of the Herbert can be selected manually by activating the red
button above each channel strip, or can be programmed via the midi control
system. If you assign the Channel one switch function to a MIDI program (for
example “01”), then you can initiate this channel’s switching via your MIDI
pedal. Push “01” on your MIDI pedal after programming, and the pedal will send
digital information to the amplifier. The amp will read this information and decide
whether or not it is supposed to respond. When properly programmed, it will then
switch on channel one.
OK, here it is again:
Select 01 on your MIDI pedal. Select channel one of the Herbert. Now push
“Store” twice. Voila, it’s a MIDI program! Now select program change “02” on
your pedal, switch the amp to channel two, hit “Store” twice, and suddenly you
have a MIDI pedal controller with 2 program changes. Continue on until you run
out of channels, about 1 more time.
All the other functions of the amp can be programmed in the same exact way.
Remember: push “Store” twice to finalize a MIDI program procedure. Select the
program on the pedal to recall the setting from the amp.
6.3
Mid Cut On/Off
The switching function “Mid Cut” is applicable to all channels. The Mid Cut is
active when the corresponding LED is lit.
6.4
Loop On/Off
This function activates a device that is connected to the switch-able loop.
6.5
Mute On/Off
“Mute” silences the beast. “Tuner Out” stays active. Makes sense, no?
6.6
Master 2 On/Off
Master 2 can be used for all channels, much like the Mid Cut function.
