•
11
•
dO NOT operate the jump starter if you, the jump starter, the device being
5.
operated or any other surfaces that may come in contact with any power
source are wet. Water and many other liquids can conduct electricity, which
may lead to serious injury or death.
do not place the jump starter on or near heating vents, radiators or other
6.
sources of heat.
do not place the jump starter in direct sunlight. The ideal air temperature
7.
for operation is between 50° and 80°F.
do not use the inverter near an open engine compartment where fumes or
8.
gases may accumulate.
do not modify the AC receptacles in any way.
9.
Using the Inverter
8.10
It is important to know the continuous wattage of the device you plan to use
with the inverter. The jump starter must be used with devices drawing 400
watts or less. If the wattage is not marked on the device, use only devices that
draw less than 4 Amps of AC current.
devices like Tvs, fans or electric motors require additional power to start
(commonly known as the “starting” or “peak power”). The jump starter can
supply a momentary surge in wattage; however even devices rated less than
the maximum 400 watts can exceed the inverters surge capability and cause
an automatic overload shutdown.
do not use the inverter with a product that draws a higher wattage than the
inverter can provide, as this may cause damage to the inverter and
the product.
Make sure the device you are using is compatible with a modified sine
wave inverter.
Always run a test to establish whether the inverter will
operate a particular piece of equipment or device.
In the event of a power overload, the inverter is designed to automatically shut
down. This safety feature prevents damaging the inverter while testing devices
and equipment within the 400-watt range.
If powering more than one device, start one device at a time to avoid a power
surge and/or inverter overload. The surge load of each device should not
exceed the inverter’s Continuous Operation wattage rate.
If you are using the power inverter to operate a battery charger, monitor the
temperature of the battery charger for about 10 minutes. If the battery charger
becomes abnormally warm, disconnect it from the inverter immediately.
You can use an extension cord from the inverter to the device without
significantly decreasing the power being generated by the inverter. For best
operating results, the extension cord should be no longer than 50 feet.
This inverter uses a nonsinusoidal waveform. Therefore, we
do not recommend you use it to power the following devices:
Switch Mode Power Supplies;
1.
Linear Power Supplies;
2.
Class 2 Transformers;
3.
Line Filter Capacitors;
4.
Shaded Pole Motors;
5.
Fan Motors;
6.
Microwave Ovens;
7.
Содержание Portable Power 1150
Страница 2: ......
