DieHard Portable Power 1150, Руководство оператора

Страница: 11 / 17

•
8
•
After the engine starts, disconnect the black clip (-) and then the red clip (+) 4.
in that order.
Recharge the jump starter as soon as possible after use.
5.
Risk of Explosion.
To prevent sparking, NEvER allow the clips to touch together or to
contact the same piece of metal. Never attempt to jump start a
frozen battery.
Powering a 12v DC Device: 8.3
The jump starter is a power source for all 12v dC accessories that are
equipped with a 12V accessory plug. Use it for power outages and fishing or
camping trips. Estimated usage time is listed in the chart below.
Make sure the device to be powered is OFF before inserting the 12v dC
accessory plug into the 12v dC accessory outlet.
Ensure that the battery clips are securely clipped on the storage holders. 1.
Open the protective cover of the dC power outlet on the front of the 2.
jump starter.
Plug the 12v dC device into the dC power outlet, and turn the 12v dC
3.
device on (if required).
If the 12v dC device draws more than 15A or has a short circuit, the 4.
internal circuit breaker of the jump starter will trip and disconnect the
power to the device. disconnect the 12v dC device. The breaker will
automatically reset after an overload occurs.
The dC power outlet is wired directly to the internal battery. Extended
operation of a 12v dC device may result in excessive battery drain. Recharge
immediately after unplugging the 12v dC device.
Appliance Type Estimated Wattage Estimated Usage Time
Cell Phone 4 watts 66 hours
Fluorescent Light 4 watts 66 hours
Radio, Fan 9 watts 29.3 hours
depth Finder 9 watts 29.3 hours
Camcorder, vCR 15 watts 17.6 hours
Electrical Tool 24 watts 11 hours
Electrical Cooler 48 watts 5.5 hours
Car vacuum, Air Compressor 80 watts 3.3 hours
NOTE: Estimated run-times. Actual time may vary. Times are based on the
internal battery being fully charged and in good condition.
Using the USB Port 8.4
The USB port provides up to 500mA at 5v dC.
NOTE: When using the USB port, the clips on the jump starter are live and will
produce arcing or sparking if they come in contact with each other. To prevent
accidental arcing, always keep the clips on the storage holders when not using
it to jump start a vehicle.
Ensure that the battery clips are securely clipped on the storage holders. 1.
Plug the device into the USB port on the front panel. 2.