Safety
•
The device is equipped with a safety-tested power cable. Connect this power cable only to a groun-
ded socket.
•
Always hold the plug when removing the power cable. Never pull on the cable itself.
•
Lay all connecting cables in such a way that they will not be stepped on or tripped over, damaged or
crushed in any way.
•
Have damaged power cables replaced immediately.
•
Make sure that there is always free access to the electrical sockets used or to the electrical circuit-
breakers of the house installation.
DANGER
In case of an emergency (e.g. damaged cabinets, controls or power cables, liquids or for-
eign objects in the device) take the following steps:
Switch the device voltage-free immediately by:
● Switching off the automatic circuit breaker or removing the fuse insert from the fuse
holder in the distributor box of the house installation.
● Disconnecting the plug of the power supply cable from the grounded socket in the build-
ing installation.
● Interrupting the power connection (see chapter "Introduction", section "General power
interruption" in the operating manual);
● For further system-specific notes, please refer to the operating manual.
● Inform the customer service responsible for you.
•
Never connect or disconnect data transmission lines during a thunderstorm.
•
Always keep the device’s ventilation openings free from obstruction to ensure proper ventilation and
to prevent malfunctions resulting from overheating.
•
Only use accessories and extension components that have been approved by us. Nonobservance
can result in damage to the system or violations of regulations concerning safety, radio interference
and ergonomical requirements.
•
Note that there are only safety extra-low voltage circuits (SELV circuits) if you want to feed voltage
from an external source into prepared cables to install additional electronics (e. g. EMA connection).
•
To clean the device only use cleaning agents approved by Diebold Nixdorf (see chapter "Cleaning,
Service and Maintenance" in the operating manual).
•
Components with adjustable light effects are integrated in this product. Repetition frequencies
between 5 Hz and 40 Hz should be avoided as certain light frequencies or flickering light sources can
cause epileptic seizures in some individuals.
Also avoid light reflections and synchronize the cycles wherever possible. Ensure that monitors' refresh
rates are as high as possible.
Copyright © 2020, Diebold Nixdorf
01750334554C
2-2
