© DICTATOR Technik GmbH • Gutenbergstr. 9 • 86356 Neusäß • Germany
Tel. +49(0)821-24673-0 • Fax +49(0)821-24673-90 • E-mail [email protected] • 20200430
Page 07.045.3
Technical Manual
DICTAMAT OpenDo
Page 07.045.03
1. General Notes
This manual is intended for qualified personnel only. Installation may
only be carried out by technically trained and qualified persons. The
electrical connection may also only be carried out by a specialist.
This document contains important information on installation, electrical
connection and commissioning of the product.
The document must be read before any work is carried out on the
electrical and electronic systems and must be kept accessible at all
times as part of the product.
In addition to this document, other documents, directives, standards
and laws for products of this type must be observed.
ATTENTION!
Danger to life from electric shock!
Dangerous injuries, death and damage to property can be caused by
dangerous electrical voltages!
The operation of all components is only permitted in undamaged condition.
Always disconnect from the power supply before carrying out any work and
secure against being switched on again.
The accident prevention regulations must be observed.
Cable
Type of cable
Between motor and controller up to 20 m:
20 to 50 m:
50 to 100 m
Rotary encoder:
up to 50 m:
2 x 0.50 mm²
2 x 0.75 mm²
2 x 1.50 mm²
4 x 0.25 mm²
Between push button and
controller
optionally
up to 50 m:
4 x 0.25 mm²
Between power pack and
controller
up to 20 m:
20 to 50 m:
50 to 100 m:
2 x 0.50 mm²
2 x 0.75 mm²
2 x 1.50 mm²
1a) Target Group
1b) Warning Notice
1c) Requirements
1d) General Safety
Instructions
1e) Cables to be Used
