The
dicodes Dani Box
can be used in 5 different modes. 3 of the modes are only
available if the Expert-Mode is set to 1.
The additional modes available with Expert Mode set to 1 are “Power Boost”, “Heater Protection” and
“Bypass”.
Here is an overview of the modes:
1.
Standard:
Vaping with a constant power setting. The selected power is applied to the coil, unless
the coil’s resistance affords a different power setting.
2.
Temperature
Control:
The power applied to the coil is calculated by a temperature controller which keeps the
coil’s temperature constant. NOTE: Set the correct temperature coefficient and
perform a calibration at room temp.
3.
Power Boost: The coil is quickly heated up initially. Moreover a repetitive boost can be selected.
Note do not to set the power limit to a value too high. It’s best to use a lower than
normal power setting.
4.
Heater
Protection: The power to the coil is repeatedly interrupted to enable a liquid flow and to limit
the temperature.
5.
Bypass: The mod behaves like a mechanical mod, i.e. the battery voltage is applied directly to
the coil. The maximum current is limited 20A. Note that the vape now depends on
the amount of power in the battery. Also the coil should not be very low in resistance
as then 20A limit could be reached easily.
With “Set Defaults” it is possible to return all settings to the the default status.
The reset is initiated by selecting the menu and pressing a button. To avoid unintended
resetting the user has to confirm the procedure by again pressing the button when
“confirm” is displayed. “Process” shows while the rest is performed.
Most of the defaults are listed in the overview diagram of the Extended Functions Menu. Here
are the additional settings which are not listed in the Extended Menu:
Power:
Temperature:
Heater Control Mode:
Wire Type:
10W
210°C
1 (Standard, normal VW)
NiFe (320)
l
d
n
06 Extended Functions Menu
Additional explanation to several menu items, page 2
Содержание Dani Box
Страница 1: ...Dani Box manual ...
