www.dickinsonmarine.com
~
Form#7.2-248 Issue#2
12
Stove Installation Diagram
Securing your Stove
When installing your Dickinson stove it is recommended that you bolt it
down using the 4 holes provided (2 on the bottom of each leg). The rear bolt
holes can be hard to reach so instead you can use the tie down bar (provided)
instead. Firstly mark where your stove is going to be located. Then screw
down the tiedown bar so that it allows your heater to slide with the feet
sliding underneath the upraised ends. Ensure that the tie down bar contacts
the stove somewhere between the middle and rear of the stove. Once in
place secure the front of your stove through the bolt holes. The tie down bar
alone will not secure your stove. It only prevents upward movement such as
tilting. If not secured otherwise, your stove will be at risk of sliding in high
seas.
