FunCTIonInG
EN
DiBO 23
Functioning
SET TO WORK
Turn the key contact to position 1 (=on) and wait till the lamp of preheating is
extinguished, then turn the key contact further to position 2 (=STaRT) to start
the fuel engine. leave the key when the fuel engine is started. The automatic
speed control option has a fixed setting on 50 %. When the fuel engine is
running, allow the engine to warm up at stationary revolutions. point the spray
gun in to the open space and operate the spray gun until the water supply
is completely de aerated. operate the spray gun and adjust if necessary the
spray pressure by operating the control stick. For the use of hot water, set the
temperature on desired value through the control stick and by following the
instructions of the temperature menu on the display (see
). after turning 30 minutes into bypass, the cleaner will switch off
and an indictaion will be visualized on the display. When the autostart function
is active and the cleaner switches off (after x seconds) , the display will light up
alternately grey. The machine is now in stand-by position (see control screen 6)!
Pay attention: the cleaner can start automatically in stand- by position!
CONTROL COMPONENTS
1 KEY SWITCH
(SEE alSo:
“VISUAL PERCEPTION” ON PAGE 16
The main switch is a key switch and is equipped with three positions:
• on: The JMB will be switched on electrically without however starting the
engine. after switching on, all sensors will be tested automatically and the
glowing process of the engine starts.
• STaRT: as soon as the indication “preheating” is gone, the engine can be
started.
• STop: By turning the key back to the left the engine will be switched off again.
2 CONTROL STICK
The control stick is a switching element with four possible switching positions
(left/right/above/below) and a zero position (middle). This coordinate switch is
suitable for simple navigation in the 4 selectable directions.
3 DISPLAY
on the display you receive possible disturbances and the operating instructions
will be displayed if desired.
you also receive a message when service is necessary / desired, receive status
info of the cleaner and check working hours of the machine.
other operating possibilities will be displayed by means of operating the control
stick (see
“Display / failures” on page 25
). The functioning of the control
panel will be described further in this chapter.
4 EMERGENCY STOP
The emergency stop can be recognized on the red pressing button at a
yellow slice. The display screen will be disappeared (powered off) when the
emergency stop is pushed.
• push the emergency stop: the machine stops immediately at emergency
situations.
• pull out the emergency stop: the machine can be restarted.
5 FUSES
The electrical part off the JMB is protected by different fuses. This fuses are
mounted in the electrical control box which is mounted on the burner (it is
recommended to replace the fuses by a qualified technician).
Pay attention: always switch off the machine and
uncouple the battery before replacing a fuse(s)!
