Diamondback 910Er, Руководство пользователя

Страница: 9 / 44

910Er Owner’s Manual
9
ASSEMBLY INSTRUCTIONS
1. Unpack the 910Er from the carton. Please recycle.
2. Verify the carton contains all parts from the list.
3. Install the four (4) stabilizer feet assemblies ( A1 &
A2 ) into the under ‐ side of the front and rear
stabilizers. Thread all the way in.
4. Remove the eight (8) Allen screws ( F1 ), eight (8) lock
washers ( F2 ), four (4) flat washers ( F3 ) and four (4)
curved washers ( F4 ) from rear frame assembly B and
set aside.
5. Remove the two (2) Allen bolts G1 from the left and
right sides of the console mast assembly ( C ) and set
aside.
6. Stand the rear frame assembly ( B ) right ‐ side up and
lay the console mast assembly ( C ) nearby. Join
connectors D and E firmly to ensure a good
connection.
7. Carefully stand console mast assembly C upright and
join with the rear frame assembly ( B ). Ensure rear
assembly ( B ) is fully inserted into the console mast
receiver ( C ) by confirming the bolt holes are aligned.
8. Install, by hand, the four (4) Allen screws, lock
washer & flat washer assemblies ( F1 , F2 & F3 ) into
the sides of console mast assembly B. Thread the
four (4) Allen screws, lock washer & curved
assemblies ( F1 , F2 & F4 ) into the top and bottom of
the frame. Once all bolts are partially installed,
tighten each firmly with the enclosed Allen wrench.